Connect HereLink and QGround Control via WiFi
Wirelessly connecting a HereLink to QGroundControl through a local WiFi network.
Last updated
Wirelessly connecting a HereLink to QGroundControl through a local WiFi network.
Last updated
The HereLink uses an Android operating system. The instructions below reflect this.
IMPORTANT! Before performing the following procedure, connect the device on which QGC is installed (tablet or laptop), to the WiFi network that the HereLink will be connected to.
1
On the HereLink, go to the Settings > About phone > Status information > IP address. Record the IP address of the HereLink for later use.
2
On the HereLink, go to Settings > Connections > WiFi, and connect the HereLink to a local WiFi network.
3
On the GCS, open QGroundControl (QGC).
4
Locate the QGroundControl icon in the upper-left corner of the screen (Fig. 1). Press this icon to open the Select Tool window (see next page).
5
In the Select Tool menu (Fig. 2), click on Application Settings.
6
A selection menu opens in the upper-left corner of the screen (Fig. 3). Select Comm Links
7
A selection menu appears at the bottom of the window (Fig. 4). Select Add.
8
A dialog box, Create New Link Configuration, appears (Fig. 5).
9
Enter a name for the Comm Link (Fig. 6 below). In this example, the name we created is “IF1200A”
10
Select Automatically Connect on Start
11
In the Type field, select UDP
12
In the Port field, verify it is set to 14550
13
In the Server Addresses (Optional) field, enter the IP address of the Herelink (see Step 1)
14
Click on OK at the bottom of the dialog box
15
The Create New Link Configuration dialog box closes, and the new Comm Link name that you created (IF1200A) appears at the top of the screen.
16
To connect the GCS to the HereLink, select the new Comm Link to the HereLink (IF1200A), at the top of the screen, then click on Connect at the bottom of the screen
17
Once the aircraft and HereLink are wirelessly connected, the GCS begins issuing audible signals. This may take a few moments.
