User Guide

Overview of how to use Air Commander Equipped Integrations

Quick Start

1	Start with the drone and camera powered off, with the payload attached to the drone via the Gremsy quick connector. For payloads with an externally routed HDMI cable, connect this as well, ensuring that the gimbal can rotate through it's full range of motion (pay particular attention to the pan axis) without pulling on the cable.
2	Power ON the drone, and allow the gimbal to initialize.
3	Power ON the camera (excluding RX100, it will automatically power on).
4	Allow camera and Entire R3 to fully initialize and connect, around 30 seconds.
5	Fly mission
6	After landing, allow Entire R3 to geotag photos. It's status LED will quickly flash white, and the cameras display will indicate processing.
7	To remove photos from the camera, carefully disconnect multiport USB from camera, and connect micro USB cable from a computer to the camera. Copy files from the camera to the computer, then reconnect multiport cable to the camera.
8	To erase files from the camera, use the camera's built in menu system.

Mavcam and Herelink Control

Swiping

Main handle is used as shortcut to other menus via Swiping:

SWIPE GESTURE	ACTION
Right	MavCam Configuration
Up	Camera Configuration (Shutter Speed, Aperature... etc.) Camera configuration panel has small handle at right edge, which will expand panel with information about Entire status, and Entire configuration
Left	Hide MavCam This is handy when you need to use software keyboard, where sometimes MavCam interfere with ENTER key. Swipe up in the middle of bottom screen to re-open MavCam.

Buttons

BUTTON	COMMAND
C & D	You can enable capturing of C & D buttons on the HereLink by MavCam. Then you can use C & D buttons to control exposure or zoom.
LONG PRESS D	Open popup window, where you can select function to be controlled
SHORT PRESS C or D	Will execute selected function

WARNING!

C & D buttons must be disabled in other applications, otherwise will execute also other configured functions under QGC or Solex, or HereLink settings.

HereLink Black MavCam Controller Commands

Zoom Handle

Zoom and focus panel are scrollable! When you opened Camera control panel, there is a few exposure tools.

Zoom

ZOOM handle reacts to PLUS or MINUS clicks as all others, but you can also swipe the ZOOM icon in the center to the left or right.

Swiping left or right will give you proportional zoom control if camera supports this feature.

Focus

If your camera supports proportional focusing, you can also use this sliding approach for focus tool (currently supported only for PhaseOne cameras).