IB388 Battery Charging

Charging the IB388 batteries.

STEP
ACTION

1

Ensure the IMARS D300 Charger is plugged into a 120VAC outlet and is in the idle state.

2

Press the Battery Indicator Button on the IB388 Battery to wake up the battery. It will start flashing green.

NOTE: Sometimes the center button can be difficult to press and more force is required.

Note

Status LED should flash green.

3

Plug in the yellow XT60 into the CHA port on the D300.

4

Next connect the IB388 to the battery connector of the charge cable.

A Pop-up window will appear asking you to Confirm the battery is IB388.

5

Press the Up arrow then Enter/Setting button to select ‘Yes’. Charing will begin.

6

Verify the IMARS D300 is charging.

The charger will display:

  • Time it has been charging

  • Current

  • Voltage

  • mAh charged

NOTE: "Charging #%" on the chargers can be inaccurate. Best practice is to wait until the charger has gone to an idle state and then check the State of Charge using NFC and /or LED indicators.

7

Verify the IB388 Battery Light is Solid Blue to indicate Charging.

NOTE: Light may flash blue at any time throughout the charge for cell balancing. This is normal.

8

The charge is completed once the charger has gone into an idle state.

WARNING: Disconnecting the charger plug while the battery is charging may damage the battery.

9

If you need to cancel charging stop the charger first by selecting the Enter/Setting button until it shows the battery has entered 'idle's state before unplugging the battery.

Last updated