Mounting & Detaching LR1 to Dovetail

For information on how to swap from Vio to the LR1 with Herelink and IGC go here.

Mounting the LR1 to the Aircraft Dovetail:

  1. Align payload dovetail connector with the aircraft dovetail socket and insert the dovetail connector into the dovetail socket. When fully inserted the safety latch will click.

When attaching payloads to the dovetail, line up and slide in along the red dashed lines.
  1. Push the quick release lever on the side of the dovetail socket towards the aft (back) of the aircraft. You will feel the tension of the quick release lever get tighter as you press the lever all the way against the dovetail mount.

After sliding into the dovetail, tighten the red lever flush against the dovetail mount by latching it into place as shown on the right.
  1. Ensure that the LR1 payload is straight and level prior to turning on the system. (see image below).

The LR1 payload needs to be straight and level prior to turning on the aircraft, as above.

Detaching the LR1 from the Aircraft Dovetail:

  1. Unlock the red lever by pulling it towards the front of the aircraft.

To detach, open the red lever as shown on the right.
  1. When the lever is in the open position, press the red safety latch on the opposite side of the dovetail mount, then pull the payload towards the front of the aircraft until it slides free.

To remove the payload from the dovetail, press the red safety latch and slide out.

Last updated