Pairing HereLink Radio

Should the HereLink Controller become disconnected to the Air Unit, follow the following procedure to repair them for your aircraft.

Tools required:

• 2mm Hex Screwdriver

• Plastic, angle-tip spudger or probe tool

• Flashlight

STEP	ACTION
1	Locate the UPI panel on the underside of the aircraft. Remove the UPI Panel by unscrewing (4X) - M2.5 Socket Head Screws using a 2mm Hex screwdriver.

Payload shroud on the underside of the aircraft.

2	Use a flashlight to identify the HereLink Air Unit through the UPI panel port. The air unit is inside and toward the lower front of the aircraft. Locate the “Pair/Reset” button on the HereLink Air Unit.
3	Turn on the aircraft pressing the Power Button on the back of the aircraft.
4	Power on the HereLink Controller module with the power button.
5	Open the HereLink Settings App on the controller (green gear icon).
6	Navigate to the “RADIO” tab. NOTE: Once the (controller) “PAIR” button has been pressed you have 30 seconds to pair the controller with the drone. If this window is missed, re-select the “PAIR” button.
7	Press the “PAIR” button on the HereLink controller in the top right of the menu.
8	Use a nylon angle-tip probe or similar to depress and hold the “Pair/Reset” button on the HereLink Air Unit until the HereLink Controller screen says “Pairing Successful” and the “Uplink Rate” is displayed.

On the IF800, the HereLink Air Unit is mounted upside down.

Nylon tool